To provide more selection of the cable type In order to achieve the best transmission effect (VSWR approaches 1) in RF fields,we will concentrate the specifications for the correspondence between connectors and cables. For example, the Japan specification (4C, 5C) or US specification (RG-59, RG-6U) and other specification and impedance, You must choose the same specification and impedance for the connectors and cables. The definition of the specifications is to maintain a connection after assembly and retain a fixed percentage of the section conductor and insulation diameter ratio. In case of the unclear specification or the cable has only marked with 50 or 75 ohm, it will create a situation where no corresponding connector. Under these circumstances, ABC-0701 will be proposed a solution on it. In a specified size range for the cables, it will allow cables to retain a fixed percentage of the section conductor and insulation diameter ratio after complete assembly and also achieve the best transmission effect.
Mechanical structure: Contact pin uses the barb hook into the insulation for operate when assemble (Contact pin will not be assemble when deliver) The body and the insulation will used the barb hook to operate when tighten, and use the middle piece shell with punch riveting to fix. The BNC interface shell use spring and washer to cove on the body and it can spin independently. The final part and middle part of the shell locked by screwing, and to fix with the cable and the shell stable by a screw.
Material: Contact Pin: Tellurium Copper (#C14500 / copper contain over 99%) Body: Tellurium Copper (#C14500 / copper contain over 99%) Spring: Steel Washer: Steel Shell: Brass Screw: Iron